[Trust]

Hello guys,
played the update yesterday and really like it.

I had one problem, i tried to build a pillar in the middle of a circle of triangle foundations.
I couldnt place it, so i couldnt close my roof.

Maybe i did something wrong.
If you get some expirience with that it would be nice to share if there is an solution.

If not i request to be able to place them there.

Greetings

[TpsTheHunter]

Use walls, only way to get dat stability up.

[kulan]

Triangle floors require 2 anchor points to be stable. You can remove walls(I use doorways easier to manoeuvre around) after placing floors. But they don't always stay up.

I have noted that with triangle floors more than any other part it's stability is not a constant.
I.e if you place a triangle floor between 2 anchor points you might get 30% stability if you remove it and place it again without any other changes it might be 37% stability.

[GrymThor]

Trust posted:

Hello guys,
played the update yesterday and really like it.

I had one problem, i tried to build a pillar in the middle of a circle of triangle foundations.
I couldnt place it, so i couldnt close my roof.

Maybe i did something wrong.
If you get some expirience with that it would be nice to share if there is an solution.

If not i request to be able to place them there.

Greetings

You need to do this, once the circle of triangle foundations are placed, build three door frames in the center as the picture below shows



Then place your triangle floors for your ceiling to seal it off. Afterwards delete the door frames and you should get something like the following picture.